Differences

This shows you the differences between two versions of the page.

--- docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:15] – [Kernel installation] arekm
+++ docs:man:installing_pld_linux_based_on_rescue_cd [2024-11-13 13:35] (current) – [Partition disk] anything there arekm
@@ Line 14: / Line 14: @@
 ===== Partition disk =====
 Use for example ''cfdisk'' to partition your destination disk. Usually root partition (/) and swap is enough.
+There are many ways you can partition your disk. Simple example below:
+  * cfdisk /dev/sdX (assuming fresh disk visible in system as sdX)
+  * choose GPT partition table
+  * create 10MB BIOS Boot partition
+  * create 1GB EFI System partition
+  * create Linux partition (or more partitions) for PLD
 \\ :!: Write something more here :!:
@@ Line 164: / Line 173: @@
 By default kernel installation also generates initrd based on mounted /proc, /sys, /dev files and configured fstab, modprobe.conf and few others configuration files. generated initrd (which by default is initramfs cpio image) is saved in /boot.
+----
+There are two initrd generators used in PLD: geninitrd and dracut. Choose one.
+=== geninitrd ===
 If something fails or you want to regenerate initrd manually you can do it using:
@@ Line 175: / Line 190: @@
 //-v// option causes geninitrd to write additional information, so you can see if proper kernel modules are being installed into initrd.
+=== dracut ===
+:!: Write something more here :!:
+----
 PLD supports systemd and non-systemd installations. In case of systemd installation you need to install package